Changes between Version 7 and Version 8 of Dimetra_EBTS/Site_Controller

Timestamp:

05/30/11 13:45:24 (2 years ago)

Author:

laforge

Comment:

--

Dimetra_EBTS/Site_Controller

@@ -23 +23 @@
     * A RS-232 serial port for local configuration 
 
+== Serial Console ==
+=== Boot Log ===
+{{{
+Copyright Motorola Inc. 1988 - 1996, All Rights Reserved
+
+ACG Debugger/Diagnostics Release Version 1.0 - 06/24/96
+COLD Start
+
+Local Memory Found =02000000 (&33554432)
+
+MPU Clock Speed =100Mhz
+
+BUS Clock Speed =67Mhz
+
+Keyboard not connected
+
+Initializing System Memory (DRAM)...
+
+System Memory: 32MB, Parity NOT Enabled (Non-Parity-Memory Detected)
+L2Cache:       NONE, Parity NOT Enabled
+
+
+SelfTest/Boots about to Begin... Press <BREAK> at anytime to Abort ALL
+
+ROMBoot about to Begin... Press <ESC> to Bypass, <SPC> to Continue
+_
+DEC DC21140 (rev 0x2000022) at 0x80810000, irq 9, hwaddr 08:00:3e:c4:d6:9d
+AMCC Motorola SEP/STP at 0x80840000, irq 14
+SRI site reference/watchdog at 0x80000200, board rev. 2
+Memory: 16535k/32768k available (76k kernel, 0k reserved)
+
+Access Controller Gateway
+Firmware Rev R02.03.02 (PowerPC)
+Copyright (c) 1993-1996
+Motorola, Inc.
+
+Unauthorized Access Prohibited
+
+Current status:
+
+Active/Standby Status:            UNKNOWN
+MAC Address:                      08:00:3e:c4:d6:9d
+
+To enter configuration mode, hit any key within 10 seconds:
+Waiting for ACTIVE/STANDBY status determination...
+Booting from T1 interface (hit any key to abort).
+
+
+ERROR - T1 initialization failed: Stabilization error
+
+
+
+ERROR - T1 initialization failed: Stabilization error
+
+
+
+ERROR - T1 initialization failed: Stabilization error
+}}}
+
+=== Menu ===
+{{{
+Enter "help" for a list of commands
+ACG> help
+
+Available commands:
+  dir                 - Show file directory
+  exit                - Exit configuration mode
+  go                  - Execute application code
+  help                - Print this info
+  inport              - Dump input from a serial port
+  load                - Load file into memory via ethernet
+  loadall             - Load all files into memory via ethernet
+  nvr                 - Dump NVRAM
+  outport             - Send output to a serial port
+  passwd              - Change operator password
+  reset               - Reboot this processor
+  sload               - Load S-records from serial port
+  status              - Print configuration parameters
+  ver                 - Print firmware version
+ACG>
+}}}
+
 == Images ==
 === Site Controller top view (lid removed) ===